Orenco MF Liquid Level Switch Assembly Specifications
- Three (4) model "A" normally open mercury* signal-rated switch
- Replace with: SJE-Rhombus 10MPCNO
- Cord is not color coded - see catagory page for more information
- 5 amp, 120/230 VAC 50/60 Hz
- The control switch turns on (closes) when the float tips
slightly above horizontal signaling a high level, and turns off
(opens) when the float drops slightlybelow horizontal.
- Control differential of .5 inches above or below horizontal.
- 10 ft flexible 18 gauge cord, 2 conductor (UL,CSA) SJOW,
water-resistant (CPE)jacket
- UL Listed for use in non-potable water and sewage.
- CSA Certified
- Switch not recommended for electrical loads of less than 20
milliamps, 12 VAC or non-arching electrical loads (intrinsically
safe applications)
- 45" Stem Length
- FS - Float height not established and intended to be "field set" per
project requirements
- 10' cord lengths
R.C. Worst & Company Mercury Switch Purchase Policy
Any order placed for a mercury activated float switch in a mercury
restricted state will result in an automatic exchange to a mechanical
equivalent of the product ordered. Difference in cost will result in an
automatic refund of the difference between the two products. Instances
where the mechanical alternative is more costly, our customer service staff
will contact you to make you aware of the difference in cost.
*Mercury Restricted States as of 10/01/2010: Connecticut, Rhode Island,
Maine, California, Vermont, Illinois, Minnesota, New York , Louisiana, New
Hampshire, Massachusetts, Wisconsin
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov