*This item is considered Hazardous Material and cannot be shipped via air services.

WELD-ON® 705™ is an industrial grade, clear or gray, low VOC emission, medium bodied, fast setting, high strength PVC solvent cement for all classes and schedules of pipe and fittings with interference fit through 6 inch (160 mm) diameter, Schedule 80 through 4 inch (110 mm) diameter. Can be used without primer on non-pressure systems if local codes permit.

Typical Application:

WELD-ON 705 is for use on all types of PVC plastic pipe applications, Type I and Type II. It is suitable for use with potable water pressure systems, irrigation, turf, foam core, conduit, sewer, drain, waste and vent systems. Detailed directions on making solvent cemented joints are printed on the container label. An installation DVD/CD covering solvent cementing is available. It not only describes the basic principles of solvent cementing, but also covers the handling, storage and use of our products. It is highly recommended that the installer review the instructions supplied by the pipe and fitting manufacturer.

NOTE: WELD-ON solvent cements must never be used in a CPVC system using or being tested by compressed air or gases; including air-over-water booster.

Technical Details:

• NSF Certified
• Fast Set Time
• 3 year shelf life
• ASTM D 2564, NSF/ANSI 14, NSF/ANSI 61
• CSA B137.3, CSA B181.2
• Water thin viscosity
• Use with All Rigid PVC
• Max recommended pipe size 6"

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Weld-On Product Resources:

Weld-On 705 PVC Cement Safety Data Sheet

Weld-On 705 PVC Cement Product Bulletin