Hydromatic S3SD Typical Application
The Hydromatic S3SD and SB3SD sewage pumps are designed to transfer raw
sewage with solids as large as 2½".
Hydromatic S3SD Superior Features
- Oil-filled motor for cooler operation, longer life, and less
maintenance. The dielectric oil effectively dissipates heat and lubricates
upper and lower ball bearings.
- Upper and lower ball bearings.
- Dual mechanical seal.
- The start and run capacitors are located in the control panel for
single phase motors.
- Standard construction is cast iron.
- 400 series stainless steel shafts.
- Standard 35' power cord has three conductor PVC jacket.
- Field serviceable; pumps have 300 series stainless steel fasteners for
easy tear down.
- Semi-open, two-vane sewage type impellers have pump-out vanes on back
shrouds to prevent stringy materials from building up around shaft and
seal.
- Manufactured with carbon and ceramic faced mechanical shaft seal for
long leak proof life.
- All units given complete hydraulic test run before shipping.
Hydromatic S3SD Pump Curve
Hydromatic S3SD Technical Details
- HORSEPOWER: 1.5 HP
- RPM: 1750
- MATERIALS OF CONSTRUCTION: Class 30 cast iron; ASTM A-48
- MAXIMUM HEAD: up to 44 ft. (13.4 m)
- MAXIMUM CAPACITY: up to 385 GPM (24.3 LPS)
- SWITCH TYPE: Control panel required
- MATERIALS OF CONSTRUCTION: Class 30 cast iron; ASTM
- MINIMUM SUMP DIAMETER: Simplex = 30" (762mm)
- DISCHARGE PIPE SIZE: 3" (76.2 mm) NPT
- MAXIMUM SOLIDS HANDLING SIZE: 2.5" (63.5 mm)
- CORD LENGTH: 35' STW cable
- VOLTAGE: 3ø, 208V, 60Hz
- MAXIMUM WATER TEMPERATURE: 140°F (60°C)
- MOTOR: Enclosed, oil cooled induction
- IMPELLER CONSTRUCTION: Ductile iron; ASTM 536
WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov