Our Blog

The minimum submergence of a pump is the vertical distance of liquid above the suction bell, inlet, or line required to avoid the creation of a vortex. If the vortex with it’s tornado-like, spinning movements like a whirlpool go deep enough it can cause cavitation in the pump. Cavitation is the formation and accumulation of bubbles around the impeller of the pump. Intense shockwaves inside the pump when the bubbles implode or collapse can cause impeller and/or housing damage. This, of course,...

Do you want peace of mind in knowing that your septic pump is working properly? An alarm system gives you a warning when the water has reached a high or low level in the tank. A high level alarm can indicate that too much water is being put into the system. This may be caused by increased use in laundry, dishwashing or long showers. You may have a running toilet and catching this problem can save a lot of money on your water bill. Ground water penetrating the tank can also cause a high water...

This question comes up all the time. The average life expectancy of a sump pump is 7-10 years. However, this depends on many different factors. How often the pump runs, debris in the water, the quality of the pump, and insufficient voltage are a few of the factors that can affect the life of your pump.The table below lists common troubleshooting symptoms, probable causes, and corrective actions. You will see a few causes that will indicate that it is probably time to replace your...

It’s a great time to sell your home if you live in the San Diego area. The median home price recently peaked at its highest point in over a decade. Lots of potential buyers and fewer homes for sale has led to a seller’s market in the area. To make the most of this change in the housing market, local homeowners can boost their property value by making a few home improvements. Of course, many homeowners have so many project ideas that they’re uncertain where to start. Sound familiar? If so, it’s...

How do I choose the right pump for my system? To size a pump correctly you will need to determine your required flow rate and the amount of lift required. Flow rate: The volume of water that travels through the pump in a given time (measured in gallons per minute or GPM). Lift: The amount of lift required is referred to as Total Dynamic Head (TDH). Determine Flow Rate: There are a number of different methods to determine the desired flow rate. The key to selecting the right size pump is to...